This item we ship it by DHL,FEDEX,UPS,HK Air Parcel ,EMS Etc. to USA, UK,Canada, Australia, New Zealand, Ireland, Austria, Belgium, Denmark, Germany, France, Finland, Luxemburg, Malta, Norway, Sweden, Swiss, Spain, Italy, Japan, Korea,Thailand, Malaysia, Indonesia, Philippine, Singapore.Clients from other countries please contact with us in advance to confirm the different shipping charges before you bid.
Promise |
Model | DSO5202P | DSO5102P | DSO5072P |
Acquisition | |||
Sample Rate | Real-Time Sample: 1GS/s Equivalent Sample: 25GS/s | ||
Acquisition Modes | |||
Normal | Normal data only | ||
Peak Detect | High-frequency and randon glith capture | ||
Average | Wavefom Average, selectable 4,8,16,32,64,128 | ||
Inputs | |||
Inputs Coupling | AC, DC, GND | ||
Inpits Impendance | 1MΩ±2% ‖20pF±3pF | ||
Probe Attenuation | 1X, 10X | ||
Supported Probe Attenuation Factor | 1X, 10X, 100X, 1000X | ||
Maximum Input Voltage | CAT I and CAT II: 300VRMS (10×), Installation Category; CAT III: 150VRMS (1×); Installation Category II: derate at 20dB/decade above 100kHz to 13V peak AC at 3MHz* and above. For non-sinusoidal waveforms, peak value must be less than 450V. Excursion above 300V should be of less than 100ms duration. RMS signal level including all DC components removed through AC coupling must be limited to 300V. If these values are exceeded, damage to the oscilloscope may occur. | ||
Horizontal | |||
Sample Rate Range | 500MS/s--1GS/s | ||
Waveform Interpolation | (sin x)/x | ||
Record Length | 40K | ||
SEC/DIV Range | 2ns/div to 40s/div | 4ns/div to 40s/div | |
Sample Rate and Delay Time Accuracy | ±50ppm(at over any ≥1ms time interval) | ||
Position Range | 2ns/div to 10ns/div; (-4div x s/div) to 20ms; | 20ns/div to 80us/div; (-8div x s/div) to 40ms; 200us/div to 40s/div; (-8div x s/div) to 400s | |
Delta Time Measurement Accuracy (Full Bandwidth) | Single-shot, Normal mode:± (1 sample interval +100ppm × reading + 0.6ns); >16 averages:± (1 sample interval + 100ppm × reading + 0.4ns); Sample interval = s/div ÷ 200 | ||
Vertical | |||
Vertical Resolution | 8-bit resolution, all channel sampled simultaneously | ||
Position Range | 2mV/div to 200mV/div, ±2V 200mV/div to 5V/div, ±50V | ||
Bandwidth | 200MHz | 100MHz | 70MHz |
Rise Time at BNC( typical) | 1.8ns | 3.5ns | 5ns |
Analog Bandwidth in Normal and Average modes at BNC or with probe, DC Coupled | 2mV/div to 20mV/div, ±400mV; 50mV/div to 200mV/div, ±2V 500mV/div to 2V/div, ±40V; 5V/div, ±50V | ||
Math | +, -, *, /, FFT | ||
FFT | Windows: Hanning, Flatop, Rectamgular, Bartlett, Blackman; 1024 sample point | ||
Bandwidth Limit | 20MHz | ||
Low Frequency Response (-3db) | ≤10Hz at BNC | ||
DC Gain Accuracy | ±3% for Normal or Average acquisition mode, 5V/div to 10mV/div; ±4% for Normal or Average acquisition mode, 5mV/div to 2mV/div | ||
DC Measurement Accuracy, Average Acquisition Mode | When vertical displacement is zero, and N ≥16:± (3% × reading + 0.1div + 1mV) only 10mV/div or greater is selected; When vertical displacement is not zero, and N≥16: ± [3% × (reading + vertical position) + 1% of vertical position + 0.2div]; Add 2mV for settings from 2mV/div to 200mV/div; add 50mV for settings from 200mV/div to 5V/div | ||
Volts Measurement Repeatability, Average Acquisition Mode | Delta volts between any two averages of ≥16 waveforms acquired under same setup and ambient conditions | ||
Trigger System | |||
Trigger Types | Edge, Video, Pulse, Slope, Over time, Alternative | ||
Trigger Source | CH1, CH2, EXT, EXT/5, AC Line | ||
Trigger Modes | Auto, Normal, Single | ||
Coupling Type | DC, AC, Noise Reject, HF Reject, LF Reject | ||
Trigger Sensitivity (Edge Trigger Type) | DC(CH1,CH2): 1div from DC to 10MHz; 1.5div from 10MHz to 100MHz; 2div from 100MHz to Full; DC(EXT): 200mV from DC to 100MHz; 350mV from 100MHz to 200MHz; DC(EXT/5): 1V from DC to 100MHz;1.75V from 100MHz to 200MHz; AC: Attenuates signals below 10Hz; HF Reject: Attenuates signals above 80kHz; LF Reject: Same as the DC-coupled limits for frequencies above 150kHz; attenuates signals below 150kHz | ||
Trigger Level Range | CH1/CH2: ±8 divisions from center of screen; EXT: ±1.2V; EXT/5:±6V | ||
Trigger Level Accuracy( typical)Accuracy is for signals having rise and fall times ≥20ns | CH1/CH2: 0.2div × volts/div within ±4 divisions from center of screen; EXT: ± (6% of setting + 40mV); EXT/5: ± (6% of setting + 200mV); | ||
Set Level to 50%(typical) | Operates with input signals ≥50Hz | ||
Video Trigger | |||
Video Trigger Type | CH1, CH2: Peak-to-peak amplitude of 2 divisions; EXT: 400mV; EXT/5: 2V | ||
Signal Formats and Field Rates, Video Trigger Type | Supports NTSC, PAL and SECAM broadcast systems for any field or any line | ||
Holdoff Range | 100ns ~ 10s | ||
Pulse Width Trigger | |||
Pulse Width Trigger Mode | Trigger when (< , >, = , or ≠); Positive pulse or Negative pulse | ||
Pulse Width Trigger Point | Equal: The oscilloscope triggers when the trailing edge of the pulse crosses the trigger level. Not Equal: If the pulse is narrower than the specified width, the trigger point is the trailing edge. Otherwise, the oscilloscope triggers when a pulse continues longer than the time specified as the Pulse Width. Less than: The trigger point is the trailing edge. Greater than (also called overtime trigger): The oscilloscope triggers when a pulse continues longer than the time specified as the Pulse Width | ||
Pulse Width Range | 20ns ~ 10s | ||
Slope Trigger | |||
Slope Trigger Mode | Trigger when (< , > , = , or ≠ ); Positive slope or Negative slope | ||
Slope Trigger Point | Equal: The oscilloscope triggers when the waveform slope is equal to the set slope. Not Equal: The oscilloscope triggers when the waveform slope is not equal to the set slope. Less than: The oscilloscope triggers when the waveform slope is less than the set slope. Greater than: The oscilloscope triggers when the waveform slope is greater than the set slope. | ||
Time Range | 20ns ~ 10s | ||
Overtime Trigger | |||
Over Time Mode | Rising edge or Falling edge | ||
Time Range | 20ns ~ 10s | ||
Alternative Trigger | |||
Trigger on CH1 | Internal Trigger: Edge, Pulse Width, Video, Slope | ||
Trigger on CH2 | Internal Trigger: Edge, Pulse Width, Video, Slope | ||
Trigger Frequency Counter | |||
Readout Resolution | 6 digits | ||
Accuracy (typical) | ±30ppm (including all frequency reference errors and ±1 count errors) | ||
Frequency Range | AC coupled, from 4Hz minimum to rated bandwidth | ||
Signal Source | Pulse Width or Edge Trigger modes: all available trigger sources The Frequency Counter measures trigger source at all times, including when the oscilloscope acquisition pauses due to changes in the run status, or acquisition of a single shot event has completed. Pulse Width Trigger mode: The oscilloscope counts pulses of significant magnitude inside the 1s measurement window that qualify as triggerable events, such as narrow pulses in a PWM pulse train if set to < mode and the width is set to a relatively small time. Edge Trigger mode: The oscilloscope counts all edges of sufficient magnitude and correct polarity. Video Trigger mode: The Frequency Counter does not work. | ||
Measure | |||
Cursor Measurement | Voltage difference between cursors: △V Time difference between cursors: △T Reciprocal of △T in Hertz (1/ΔT) | ||
Auto Measuerment | Frequency, Period, Mean, Pk-Pk, Cycli RMS, Minimum, Maximum, Rise time, Fall Time, +Pulse Width, -Pulse Width, Delay1-2Rise, Delay1-2Fall, +Duty, -Duty, Vbase, Vtop, Vmid, Vamp, Overshoot, Preshoot, Preiod Mean, Preiod RMS, FOVShoot, RPREShoot, BWIDTH, FRF, FFR, LRR, LRF, LFR, LFF | ||
Display | |||
Display Type | 7 inch 64K color TFT (diagonal liquid crystal) | ||
Display Resolution | 800 horizontal by 480 vertical pixels | ||
Display Contrast | Adjustable (16 gears) with the progress bar | ||
Probe Compensator Output | |||
Output Voltage( typical) | About 5Vpp into ≥1MΩ load | ||
Frequency(typical) | 1kHz | ||
Power Supply | |||
Supply Voltage | 100-120VACRMS(±10%), 45Hz to 440Hz, CATⅡ 120-240VACRMS(±10%), 45Hz to 66Hz, CATⅡ | ||
Power Consumption | <30W | ||
Fuse | 2A, T rating, 250V | ||
Environmental | |||
Temperature | Operating: 32℉ to 122℉ (0℃ to 50℃); Nonoperating: -40℉ to 159.8℉ (-40℃ to +71℃) | ||
Cooling Method | Convection | ||
Humidity | +104℉ or below (+40℃ or below): ≤90% relative humidity; 106℉ to 122℉ (+41℃ to 50℃): ≤60% relative humidity | ||
Altitude | Operating: Below 3,000m (10,000 feet); Nonoperaring: Below 15,000m(50,000 feet) | ||
Mechanical | |||
Size | Length 385mm, Width 200mm, Height 245mm | ||
Weight | 3.5KG(with Packing); 2.08KG(without Packing) |
Shipping 1. To serve buyers better, we will provide you for free with a tracking number of Registered International Standard Shipping, not Express. The shipping company will charge us additional fees for it. Please view the delivery time in the shipping terms carefully. If you would like express, please contact us on ebay. 2. Item(s) will be shipped out within 1-2 working days (expect china public holiday and Weekend) after receipt of a verified payment. 3. All items are shipped by Singapore Post Office, Hong Kong Post Office, China EMS, HNXBGH or HNPYGH, track website: [link removed by eBay] 4. It normally takes approximately 20- 30 working days (not including holiday, Saturday and Sunday) to arrive. some areas may take longer (20-40days),such as: Italy, Spain ,Russian Federation, Brazil ,Chile, Argentina, Thailand local custom clearance factors check. We will send the tracking number to you immediately after we sent out your items. We are not responsible for any loss of the mail if the item is not insured. we strongly suggest buyers who from these mentions country would better to choose $3 of insurance in case of getting lost. (Other countries or remote areas may take longer.)
Payment1. If you want to ship by DHL or Fedex, before buying, Please check your Zip if your area is belong to remote areas, if it is, you will pay an extra fee. 2. We reserve all right to refuse high bidders having negative, hidden feedback, all non-registered bidders or bidder with unpaid history. 3. We accept PAYPAL PAYMENT ONLY ! 4. If you paid by e-cheque via Paypal, we will send the item(s) to you after the payment was cleared. It normally takes 5-7 business days for payment processing. 5. Payment is expected to be completed within 3 days after auction closed. Unpaid auction will be forfeited and eBay may suspend unpaid buyer account. Return Plicy1. You have 20 days to contact us and 20 days to return it from the date it was received. If this item is in your possession more than 20 days, it is considered used and WE WILL NOT ISSUE YOU A REFUND OR REPLACEMENT. 2. All returned items MUST BE in the original packaging and you MUST PROVIDE us with the shipping tracking number, specific reason for the return, and your eBay ID. 3. We will refund YOUR FULL WINNING BID AMOUNT, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER BOTH Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement. 4. Return shipping is to be paid by the Buyer. Feedback1. We hope to received you 5 star positive feedback when you get the item. 2. We have always been trying to provide the best service and reliable products for every customer. Please contact us to resolve any issue before leaving negative feedback.we will assist you in any way possible and aim to answer all emails . 3. I believe that communication is the best way to resolve problem. Thank you !! Contact UsWith any questions,Please contact us via ebay messaging. We are committed to provide you with great service. If you are in any way dissatisfied with your purchase: 1)Please DO NOT open eBay case immediately. 2)Please DO NOT open PayPal Dispute immediately. 3)Please DO NOT leave us a low score for DSR immediately. 4)Please DO NOT leave us a neutral/negative feedback immediately. 5)ALWAYS communicate first. Please contact us via eBay message. 6) Please contact us in the period of 35 to 45 days from dispatched if you don't receive the item(s). Please DO NOT open case , We will work with you to resolve any problem. 7)We always reply messages within 1-2 business days, please check your Spam Inbox or eBay Message Box if you do not receive a response within 2 business days. Please note that we are off-duty on weekend, so messages received on weekend will be responded on Monday. If you have any inquiries, the best way to contact us is via eBay message. Thank you for your support ! Have a nice day ! |