1 x ADHESIVE GLUE GEL FOR Polypropylene, Polyethylene, PTFE, Silicone etc (4ml+4g)
A kit for bonding polyolefins and other materials difficult to bond porous surfaces. Does not drip from vertical surfaces. Contains a primer that increases the surface tension of polyolefines and modified cyanoacrylate gel. The gel may be used to bond standard materials without the primer.
HOW TO USE:
Clean and degrease thoroughly the surface to be bonded before applying the base primer. Thanks to a brush added to every bottle of the base primer this agent is applied equally and thoroughly to the surfaces. It is recommended to coat with the primer twice or three times in case of porous and irregular surfaces. The base primer is to be applied only to PP, PE and PTFE surfaces. A minute after applying it the adhesive may be applied to one of the surfaces to be bonded. The antiadhesive hair of the brush allows for application a very thin layer of the adhesive (even 0,15mm). Such a micron film gives a joint of the highest parameters with an equal distribution of adhesion forces during breaking stresses. Please note: You must not to apply the base primer to surfaces which are easy to stick (e.g. PVC) because you obtain the opposite effect from what you intended. The adhesive should be used only for one of the surfaces to be bonded.
-----------------
This information is based on current knowledge company NALMAT Trzebinia and is given to describe the product. It cannot be interpreted as a guarantee of its properties. The customer is obliged to test suitability of the product to certain applications, ensure a safe workplace and comply all applicable regulations.
We are the only official, authorized distributor of products made by Technicqll in United Kingdom. We can offer you the latest generation products and full manufacturer support.
Please check our other listings to see a wide range of DIY products made by that company.