5V 4-Channel Module with Optocoupler Isolation High and Low Level Trigger
1. module uses genuine quality relay, normally open interfaces Maximum load: AC 250V/10A, DC 30V/10A 2. using SMD optocoupler isolation, driving ability, stable performance; trigger current 5mA 3. module voltage: 5V 4. each way module can be set high or low triggered by jumper 5. fault-tolerant design, even if the control line is broken, the relay will not operate 6. power indicator (green), 4 relay status indicator (red) 7. interface design humane, all interfaces can be connected directly via terminal wiring leads, very convenient 8. module size: 73 * 50 * 18mm (L * W * H) 9. has four mounting bolts holes, hole 3.1mm, 67mm * 44.5mm pitch Module interfaces: 1. DC+: positive power supply (voltage required by the relay, there 5V, 9V, 12V and 24V choice) 2. DC-: negative power connection 3. IN1-IN4: each way based on the settings, can be high or low to control the corresponding relay Relay outputs: a 12- line interface, the interface can be directly connected to all leads, user-friendly 1. NO1 - NO4: normally open relay interfaces, relay before the vacant after the pull shorted with COM 2. COM1 - COM4 Common Interface Relays 3. NC1 - NC4: normally closed relay interface relay shorted with COM ago, after the pull- vacant High and low trigger selection ends: 1. S1-S4 in order to relay 1 way-4way high and low trigger selection 2. When com with low short circuit, triggering the corresponding relay is low, while the high end of the short com high trigger
Thank you for your purchase!