This could be due to poor circulation which is caused by lack of movement and is very common for people who cannot stand or walk very far.
The Circulation Maxx Reviver uses a non-invasive, and drug-free way to help provide relief through stimulation of lower legs.
Circulation issues mostly occur from lack of movement and are most common in elderly people or people with disabilities who are unable to stand or move as much as they need, to allow the blood to properly circulate. The areas of the body that are most affected are the feet, ankles, and lower legs. The circulation Maxx Reviver uses EMS technology to send small electrical pulses up the legs to contract the muscles to simulate movement to address some of the issues with not being as active as you’d like.
To use, just need to sit down and place both bare feet on the footpads on the device. Both feet need to be touching the pads for the Reviver to work and the pulses to be felt. It does not matter if your feet are larger than the footplates or if you have smaller feet and they do not cover the footplates entirely. The electrical pulses are the same for each section of the footplate so as long as your feet have good contact with the device, you will feel the pulses as normal. Select the power level (1-99), the EMS cycle and the timer either using the control panel on the device or using the remote. We recommend 30 minutes of use per day.
The Circulation Maxx Reviver should not be used if you have been fitted with a pacemaker, during pregnancy, if you have existing DVT, cardiovascular problems or epilepsy.
If you have any internal metal fixations, including hip and knee replacements, or screws and plates to fix bone fractures in the lower body, they must be made from titanium. It is not safe to use the Reviver with any of the above made from any other metal. You must consult with your GP before using the Reviver if you have any other health conditions. Please refer to the Instruction Manual for more information.
The reviver will not work with prosthetic limbs and is not suitable for lower limb amputees. This is due to the device needing to circulate the electrical pulses from one-foot plate to the other via each leg.
Batteries for the device and remote are not included.
The Circulation Maxx Reviver™ does not vibrate. If you cannot feel the micro pulses when you start using the Reviver, try increasing the level of the pulses, or using your hands to test it. The conductivity can be affected if you have dry skin on the bottom on your feet. This can be rectified by moisturising the skin or using the Circulation Maxx Conductive Gel.